LabVIEW is the main focusing in this project. The objective is to monitor the system running. All reading either temperature or humidity will be displayed in LabVIEW. Same goes with the running of motor to start the water sprinkler also will be displayed in this LabVIEW.
here the result for my project....
if u guys see the above picture , it shows the function of LabVIEW. LabVIEW will display fir every single thing happen in this system. As example when the Temperature sensor detect reading more than 30º and the humidity sensor detect less than 60% reading it will turn on LED at the hardware part and software part which is LED in LabVIEW. At the same time the data will sent to the relay from IC ATMEGA to switch on the motor. Based on the result above for condition 1 when the temperature less than 30ºc and humidty less than 60% ,LabVIEW will turn on the LED for humidity and will turn off the LED for temperature. It will prove either this monitoring system follow the hardware by comparising the data collected from this part. Second condition is when the temperature sensor more than 30º and the Humidity sensor more than 60% it will directly turn on LED for temperature and turn off LED for Humidity. For the third condition is when the temperature more than 30º and humidity is less than 60% both of LED will turn on. The last condition is when the temperature sensor detected reading less than 30º and the humidity sensor detected more than 60% both of LED will remain off. Function LabVIEW for this project is only for display the running of this system
so based on the result that i display i hope it will help you, understand the whole system for my project.. an the next post i will display the video of my project.. see guys in the next post... byee.....
0 comments:
Post a Comment